Table of Contents
Advertisement
Adding a Sense of Spaciousness
Editing the Loop Effect
1
Press the [TRACK] button.
2
Use the CURSOR [
] [
cursor to "REVERB" or "CHO/DLY," and press the
[ENTER] button.
The send level screen will appear.
D_Reverb.eps
3
Press the [ENTER] button.
The loop effect parameter edit screen will appear.
For REVERB
D_Reverb_Edit.eps
For CHO/DLY
D_Chorus_Edit.eps
4
Use the CURSOR [
] [
parameter, and use the dial to edit the value.
For details on the parameters for each effect, refer to
"Parameter List" (p. 84).
5
When you've finished editing, press the [EXIT]
button a number of times to return to the play screen.
The loop effect does not have "patches." Loop effect
settings are saved as part of the song data.
84
] buttons to move the
] buttons to select a
Parameter List
REVERB
This effect adds reverberation to the sound.
Parameter/
Explanation
Range
TYPE
Select the type of reverb.
Various different simulations of space are offered.
Simulates an ambience microphone (off-mic,
placed at a distance from the sound source)
used in recording and other applications.
AMBIENCE
Rather than emphasizing the reverberation,
this reverb is used to produce a sense of
openness and depth.
Simulates the reverberation in a small
ROOM
room. Provides warm reverberations.
Simulates the reverberation in a concert
HALL 1
hall. Provides clear and spacious reverber-
ations.
Simulates the reverberation in a concert
HALL 2
hall. Provides mild reverberations.
Simulates plate reverberation (a reverb unit
that uses the vibration of a metallic plate).
PLATE
Provides a metallic sound with a distinct
upper range.
This simulates the sound of a guitar amp's
SPRING
built-in spring reverb.
This reverb adds the wavering sound
MODULATE
found in hall reverb to provide an extreme-
ly pleasant reverb sound.
REV TIME (Reverb Time)
0.1s–10.0s
Adjusts the length (time) of reverberation.
PRE DELAY
Adjusts the time until the reverb sound ap-
0ms–500ms
pears.
LOW CUT (Low Cut Filter)
This sets the frequency at which the low cut
FLAT,
filter begins to take effect. When "FLAT" is
55Hz–800Hz
selected, the low cut filter will have no ef-
fect.
HIGH CUT (High Cut Filter)
This sets the frequency at which the high
700Hz–11kHz,
cut filter begins to take effect. When
FLAT
"FLAT" is selected, the high cut filter will
have no effect.
DENSITY
0–10
Adjusts the density of the reverb sound.
Advertisement
Table of Contents
