Saving The Insert Effect Settings (Write) - Roland BR-800 Owner's Manual

4
Use the CURSOR [ ] [
cursor to each effect, and use the dial to specify the
on/off status of each effect.
The icons show the status of each effect as follows.
Indication Explanation
Effect on (selected)
Effect on
Effect off (selected)
Effect off
5
Use the CURSOR [ ] [
cursor to the effect whose parameters you want to
edit, and press the [ENTER] button.
The parameter edit screen for that effect will appear.
D_Effect_Comp.eps
6
Use the CURSOR [ ] [
parameter, and use the dial to edit its value.
7
If there are other effects that you want to edit, press
the [EXIT] button to return to the previous screen,
and repeat steps 5–6.
8
If you want to save the current effect settings, proceed
as described in "Saving the insert effect settings" (the
following section).
The effect settings you edit are temporary. If you
exit the effect edit screen without saving the edited
effect patch, an "*" is displayed in front of the patch
name. If you select a different effect patch when this
"*" indication is shown, the edited effect patch will
revert to its original state, and the changes you
made will be lost.
] buttons to move the
] buttons to move the
] buttons to select a
Saving the Insert Effect
Settings (Write)
Here's how to assign a name (patch name) to the effect
settings you edited, and save them as a new effect patch.
1
Press the [EFFECTS] button.
2
Use the CURSOR [ ] [
to "NAME/WRITE," and press the [ENTER] button.
The write screen will appear.
D_Effect_Write.eps
3
If you want to enter a patch name, press the CURSOR
[ ] button.
If you don't need to change the patch name, proceed to
step 6.
D_Effect_Name.eps
4
Use the CURSOR [ ] [
enter the desired patch name.
5
When you've finished entering the patch name, press
CURSOR [ ].
6
Using the CURSOR buttons and the dial, choose the
Effect Patch that is to become the destination of the write.
7
Once you've specified the destination at which to
write the effect patch, press the [ENTER] button.
The confirmation message "Are you sure?" will appear.
8
If you're sure you want to save the settings, press the
[ENTER] button. If you decide to cancel without
saving, press the [EXIT] button.
When the data has been written, you will return to the
EFFECT screen.
* The display will indicate "Keep power on!" while the data is being
updated. Do not turn off the power while this message is shown.
Using Insert Effects
] buttons to move the cursor
] buttons and the dial to
57