Advertisement
Level
Installation
1. Connect the two sensor wires to
terminals 7 and 8 of the transmitter;
polarity is not important. See diagram
below; also refer to Transmitter
Installation Manual.
Ensure use of a suitably IP rated
cable gland to maintain the IP rating
of the transmitter.
2. Mount the sensor between the
transmitter and the liquid level,
to measure the air / medium
temperature at a representative point.
3. Avoid allowing the sensor to
become submerged.
4. Do not mount the sensor near a
heat source or in direct sunlight.
5. For the optimum response to
temperature change, do not mount
directly onto a large thermal mass.
The Emerson logo is a trademark and service mark of Emerson Electric Co.
Rosemount and the Rosemount logotype are registered trademarks of Rosemount Inc.
All other marks are the property of their respective owners.
Standard Terms and Conditions of Sale can be found at www.rosemount.com\terms_of_sale
© 2010 Rosemount, Inc. All rights reserved.
Emerson Process Management
Rosemount Division
8200 Market Boulevard
Chanhassen, MN USA 55317
T (U.S.) 1-800-999-9307
T (Intnl) (952) 906-8888
F (952) 949-7001
www.rosemount.com
www.rosemount.com
Emerson Process Management
Bleigistrasse 23
P.O. Box 1046
CH 6341 Baar
Switzerland
T +41 (0) 41 768 6111
F +41 (0) 41 768 630
Quick Installation Guide
00825-0100-4842, Rev. BA
6. To avoid false echoes, do not
mount the sensor directly in the path
of the transmitter beam.
7. The transmitter will automatically
detect and enable the sensor. Fine
adjustments to the temperature
calibration may be made; refer to the
Installation Manual supplied with the
transmitter.
7
8
Temp
Wiring Diagram
External temperature sensor
Emerson Process Management
Emerson FZE
P.O. Box 17033
Asia Pacifi c Private Limited
1 Pandan Crescent
Jebel Ali Free Zone
Dubai UAE
Singapore 128461
T (65) 6777 8211
T +971 4 883 5235
F +971 4 883 5312
F (65) 6777 0947 / (65) 6777 0743
Enquiries@AP.EmersonProcess.com
November 2010
3100 Series Transmitter
Advertisement
