Factory Setting EDID & EQ Dial - From Factory Settings are as Follows:
1. Transmitter Factory Default Setting is Set at EDID = "0" Supporting: HD (1080p@60) (1080p@30) (1080p@24)
(1080i@60)(720p@60) - 24bit 2D video & 7.1ch audio
2. Receiver E.Q. Dial Setting = "4" Supporting: 20M-25Meters (66 ft to 82 ft)
3. Proceed to Connect & Operate with Normal Installation (see reverse side). If there is no handshake or signal, Adjust EQ
Gain Control according to your CAT5e/CAT6 Cabling: from Minimum Dial Setting "0" to Maximum Setting "7"
If experiencing No Picture, Picture Flashing, or Drop-Signal then proceed to Manual Learning EDID Mode
Manual EDID Learning Mode
1. Set Learning (Copy) EDID Mode on the Transmitter (TX) unit = "7"
2. (SEE DRAWING) FIRST: Connect Transmitter (TX) unit directly to the Flat Panel Display using a HDMI cable. SECOND:
Connect the 5VDC Power Adapter. The "yellow" Status LED light must blink once for Learning (Copy) EDID to be
Successful. Now you can disconnect Transmitter (TX) from Flat Panel Display.
Note - Do not connect Receiver ( RX) unit during Learning (Copy) EDID Mode
3. Change Transmitter back to Factory Default Setting EDID = "0"
4. Proceed to Connect & Operate with Normal Installation (see reverse side). Wait for Sync
Lights (on Transmitter & Receiver) to Stop Flashing
5. If no Picture or Signal is on the Flat Panel Display then Power OFF (both Units) & Power
ON (both Units). Simply remove the 5VDC Power supplies & reconnect
NOTE - Recommended EDID setting for most cable and satellite set top boxes is
EDID "4" or "5". If no signal is displayed after manual EDID learning mode, adjust
to another EDID setting by doing the following:
1. Unplug the 5VDC power supply and HDMI cable from the Transmitter (TX)
2. Adjust EDID to desired setting
3. Reconnect HDMI cable from the source into the Transmitter (TX)
4. Reconnect 5VDC power supply to the Transmitter (TX)
QUICK INSTALL GUIDE
HDMI
Transmitter
Connect Power Supply