Quick Start - STRIKEMASTER Lithium 40V Owner's Manual

STRIKEMASTER
ASSEMBLY
(A)
1. Lithium 40v parts: Powerhead (A), Battery Charging Base (B), Battery (C)
Auger Spiral (D) sold separately, not included in the set. (Image 1)
2. Connect Powerhead to spiral, using collar bolt and hex wrench.
a. Collar bolt is located inside collar bolt threads at top of spiral (Image 2).
b. Two Hex wrench's are included: One is stored on the bottom of the Powerhead.
The other is taped to the mid-point of the spiral. Remove hex wrench from spiral
before operating.
3. Slide Battery onto Battery Charging Base using the channels on both sides guide.
Press down until you hear it click in place. Leave Battery on Battery Charging Base
until fully charged (Image 3).
NOTE: Battery is not fully charged when first removed from box.
4. When Battery Charging Base indicator shows green, your Battery is fully charged
(Image 4).
5. Once Battery is fully charged remove from Battery Charging Base. Slide battery onto
Powerhead using the channels on both sides as a guide, pressing down until you
hear it click in place (Image 5).
6. Remove blade cover from bottom of spiral and stow in a safe place (Image 6).
Your StrikeMaster Lithium 40v is ready for use.
FORWARD/ REVERSE
Your new StrikeMaster Lithium 40v has a forward and reverse capability. The Forward/
Reverse position needs to be selected when the spiral is at rest. If switched during use
the auger spiral will maintain its current direction until it comes to a complete stop.
Example:
While drilling a hole in the forward position if switch is accidentally engaged into reverse
during drill cycle, the spiral will continue in forward until the power buttons are released and the
spiral comes to a complete stop.
LED WORKLIGHTS
Your New StrikeMaster Lithium 40v has two LED lights on the bottom side of the
Powerhead to illuminate the cutting area. The lights will turn on when the operating
lock lever and POWER button are engaged. The LED lights will remain on for 30 seconds
POWER button is released.
EXTREME COLD WEATHER OPERATION
The Lithium-Ion Battery can be used in temperatures down to ((-4°F/ -20°C). If your Battery is not performing
correctly, put the Battery on the Powerhead, free spin auger out and above ice for 30 to 90 seconds depending
on how cold the unit is (the colder the unit, the more time to warm up). After this sequence the Battery will
warm up and begin operating normally.
NOTE: Always store Battery in a warm location.
LITHIUM 40v QUICK START
®
(B)
02
IMAGE 1
(D)
(C)
IMAGE 2
IMAGE 6
IMAGE 3 IMAGE 3
IMAGE 4
IMAGE 5
after