Table of Contents
Advertisement
Quick Links
OPER TING M NU L
Strike-Lite II / 4-Stroke
It is recommended that everyone who uses this product should read the StrikeMaster OPER TING
M NU L and view the videos at http://www.strikemaster.com/video.html before operating
You MUST add Crankcase Oil to
your new Auger prior to your
first use! We recommend
using StrikeMaster's
10W30 Weight
Conventional cold
weather 4-Cycle Oil
included with this auger.
FOR BEST PERFORM NCE IDLE ENGINE FOR 1-2 MINUTES
StrikeMaster Corporation
17217 198th venue • Big Lake, Minnesota 55309
Phone (763) 263-8999 • Fax (763) 263-8986
www.strikemaster.com
Strike-Lite
Strike-Lite
Strike-Lite
Strike-Lite
II II II II
• Quiet Operation
• 4-Cycle
• Unleaded Fuel
!
TTENTION
TTENTION:
BEFORE YOU ST RT DRILLING.
!
SM11
Advertisement
Table of Contents
Related Manuals for STRIKEMASTER Strike-Lite II
Summary of Contents for STRIKEMASTER Strike-Lite II
- Page 1 17217 198th venue • Big Lake, Minnesota 55309 Phone (763) 263-8999 • Fax (763) 263-8986 www.strikemaster.com It is recommended that everyone who uses this product should read the StrikeMaster OPER TING M NU L and view the videos at http://www.strikemaster.com/video.html before operating SM11...
- Page 2 StrikeMaster Corporation. Your new StrikeMaster ice auger has all of the most wanted features in a power ice auger, to assure many years of enjoyable ice fishing. Some of these features such as workmanship, engineering excellence, and dependability have long been standards at StrikeMaster.
-
Page 3: Import Nt S Fegu Rds
IMPORT NT S FEGU RDS It is recommended that everyone who uses this product should read the StrikeMaster OPER TING M NU L and view the videos at http://www.strikemaster.com/video.html before operating DO NOT use this product for any purpose other than cutting ice fishing holes. Ice augers are precision cutting tools built for the ice fisherman, and must be properly maintained and handled with caution during both cutting and transporting. -
Page 4: Stop Engine
Customer Service Continued satisfying performance from your StrikeMaster power ice auger may be assured by applying a minimum amount of preventive maintenance. When it is required the following information is intended to inform you as to where and how you may obtain additional service support. - Page 5 Oil level in operating position must be at lower mark on dipstick. • Wipe off any spilled oil before starting the engine. StrikeMaster 4-Cycle Engine Oil CHECK FUEL C UTION Do not refuel while smoking, near an open flame or other potential hazards.
- Page 6 RUNNING fter reading the operating manual, please take time to view the safety/instructional video at www.strikemaster.com, click on videos tab. NOTE: For Best Performance. llow the engine to warm up without load for a few minutes. OPER TING YOUR ENGINE...
- Page 7 1) Remove dip stick and drain oil. detergent, thoroughly drying Note: We recommend: StrikeMaster's 4-Stroke Engine 10w30 it afterward. Install it in Oil. alignment with the lines shown in illustration.
- Page 8 PROPER POSITION WHEN L YING THE STRIKE-LITE II UGER DOWN WHEN NOT IN USE Throttle side of handle down otherwise muffler or carburetor side are recommended.
- Page 9 FEDER L EMISSIONS COMPONENT DEFECT W RR NTY EMISSIONS COMPONENT DEFECT W RR NTY COVER GE - This emission warranty is applicable in all States, except the State of California Fuji Heavy Industries Lt. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein "engine") has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S.
- Page 10 LIMITED W RR NTY on Emission Control Systems - California Only - FUJI warrants to the owner of the 2005 and later engine that the engine (1)has been designed, built and equipped so as to conform at the time of manufacture with the applicable regulations of the California Air Resources Board, and (2) is free from defects in materials and workmanship that could cause it to fail to conform with those regulations as may be applicable in the terms and conditions stated below.
-
Page 11: Limited Warranty
To make claim under this warranty, write or call (763) 263-8999 directly to "CUSTOMER SERVICE", StrikeMaster Corporation at the above address for a warranty return authorization. StrikeMaster Corporation will make every effort to repair or replace the product if found to be defective within the terms of this warranty within 30 days after receipt of the product. - Page 12 For Information on our Tune-Up Service, please visit our website at www.strikemaster.com or call 763-263-8999 PLACE STAMP HERE StrikeMaster Corporation 17217 198th venue Big Lake, Minnesota 55309...