Maintenance - STRIKEMASTER Lithium 40V Owner's Manual

MAINTENANCE

Read the maintenance schedule and observe these recommendations to extend the life of your ice auger.
Good maintenance is essential for safe, economical, and trouble-free operation. To help you properly care
for your Powerhead, the following pages include a maintenance schedule, routine inspection procedures,
and simple maintenance procedures using basic hand tools. Other service tasks that are more difficult,
or require special tools, are best handled by professionals and are normally performed by a technician or
other qualified mechanic.
The maintenance schedule applies to normal operating conditions. If you operate your Powerhead under
unusual conditions, such as sustained high-load, or use in unusually wet conditions, consult StrikeMaster
customer service for recommendations applicable to your individual needs and use.
MAINTENANCE AND SCHEDULE
MAINTENANCE ITEM
CHECK BOLTS AND NUTS
CHARGE
BATTERY
PACK
REPLACE
CYCLE
One complete use from full charge to no charge. (If used to 75% charge, it counts as 25% of cycle.
TRANSPORTING YOUR ICE AUGER
Remove the Battery when transporting the auger.
LONG-TERM STORAGE
If your ice auger will not be run for more than one month, prepare it for long-term storage.
1. Charge the battery to full and leave it off of the ice auger. DO NOT leave the Battery on the Battery
Charging Base.
2. Remove the auger from the Powerhead and apply a thin layer of grease to the driveshaft.
3. Remove all debris from Auger and Powerhead.
4. Keep in a dry, moisture-free area.
BEFORE EACH DAYS USE
X
X
—
EVERY 400-500 COMPLETE
CHARGES/CYCLES
—
—
X
®