Summary of Contents for STRIKEMASTER LaserMAG Xpress
Page 1
2 Horsepower / 2 Stage / 4 Blade Power Auger 2000 2 Horsepower ATTENTION: FOR BEST PERFORMANCE IDLE ENGINE FOR 1-2 MINUTES BEFORE YOU START DRILLING. StrikeMaster Corporation P.O. Box 567 • 17217 198th Avenue • Big Lake, Minnesota 55309 Phone (763) 263-8999 • Fax (763) 263-8986 www.strikemaster.com SM06...
Page 2
1946. And, there is no doubt that this year's model is the finest ever produced by StrikeMaster Corporation. Your new StrikeMaster ice auger has all of the most wanted features in a power ice auger, to assure many years of enjoyable ice fishing.
Page 3
IMPORTANT SAFEGUARDS It is recommended that everyone who uses this product should read the StrikeMaster OPERATING MANUAL and the TECUMSEH engine OPERATOR'S MANUAL before operation. DO NOT use this product for any purpose other than cutting ice fishing holes. Ice augers are precision cutting tools built for the ice fisherman, and must be properly maintained and handled with caution during both cutting and transporting.
Page 4
The following information is intended to inform you as to where and how you may obtain additional service support. StrikeMaster Corporation at 763-263-8999 for the service center nearest you. Or visit our website under service centers for a full list of authorized service centers: www.strikemaster.com/service.html...
Page 5
OPERATOR’S MANUAL and MAINTENANCE INSTRUCTIONS for TECUMSEH TMO 49XA MODEL HORIZONTAL/VERTICAL CRANKSHAFT • AIR COOLED • TWO-CYCLE ENGINE THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH IF NOT FOLLOWED COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND OTHERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL AND ANY PROVIDED WITH THE EQUIPMENT ON WHICH THIS ENGINE IS USED BEFORE ATTEMPTING TO OPERATE YOUR TECUMSEH ENGINE.
Page 6
CHECK THE FOLLOWING: BEFORE STARTING A. BE SURE EQUIPMENT IS IN NEUTRAL GEAR WITH READ ALL INSTRUCTIONS PROVIDED WITH THE EQUIPMENT C L U T C H E S , B E L T S , C H A I N S A N D S A F E T Y ON WHICH THIS ENGINE IS USED.
Page 7
Figure 4 STOPPING Move remote control on equipment or any ignition stop switch in engine to “STOP” or “OFF” (see equipment manufacturer’s instructions). See Figure 2. AFTER ENGINE IS STOPPED: A. Close air vent screw on fuel fill cap (if so equipped, Figure 5 see Figure 2).
Page 8
STORAGE MAINTENANCE (continued) NEVER STORE ENGINE WITH FUEL IN TANK INDOORS OR IN ENCLOSED, POORLY VENTILATED AREAS, MUFFLER AND CYLINDER EXHAUST PORTS: WHERE FUEL FUMES MAY REACH AN OPEN FLAME, The muffler and cylinder exhaust ports require cleaning SPARK OR PILOT LIGHT AS ON A FURNACE, WATER after every 75 - 100 hours of operation.
Page 9
WARRANTY AND REPAIR For engine adjustments, repairs, or warranty service not covered in this manual, contact your nearest AUTHORIZED TECUMSEH SERVICE OUTLET. It is listed in your telephone book yellow pages under “Engine, Gasoline”. Tecumseh manufactures are responsible only for the engine used on this power equipment. If repair or service is needed for unit, other than engine, contact service source as recommended by equipment manufacturer.
Page 10
CALIFORNIA & USA EPA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The U. S. Environmental Protection Agency (“EPA”), the California Air Resources Board (“CARB”) and Tecumseh Products Co. are pleased to explain the Federal and California Emission Control Systems Warranty on your new small off-road engine. In California, new 1995 and later small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards.
Page 11
To make claim under this warranty write or call (763) 263-8999 directly to "CUSTOMER SERVICE", StrikeMaster Corporation at the above address for a warranty return authorization. StrikeMaster Corporation will make every effort to repair or replace the product if found to be defective within the terms of this warranty within 30 days after receipt of the product.
Page 12
If you have further concerns, or have any questions regarding our above mentioned services, please call during regular business hours (763) 263-8999 or write to StrikeMaster Corporation, P.O. Box 567, Big Lake, Minnesota 55309.
Need help?
Do you have a question about the LaserMAG Xpress and is the answer not in the manual?
Questions and answers