Select Light Operate/Dark Operate - 4-Pin Models - Banner VS8LEJ Instruction Manual

Method Action
Press and hold push button > 1 cycle of
Push Button
operation.
Remote Pulse remote input wire > 1 cycle of
Input operation.
3.7 Select Light Operate/Dark Operate – 4-Pin Models
Change the sensor operation to light operate or dark operate for the desired application. Use either the button or the remote
input wire procedure to configure the sensor.
Method Action
Push Press and hold the button for longer
Button than 10 seconds.
Press the button until the desired
operation is selected, then release the
button and wait 10 seconds.
Remote Pulse the remote input wire to + V dc for
Input longer than 10 seconds.
Wire
Pulse the remote input wire to + V dc for
4 to 1000 ms until the desired operation
is selected and wait 10 seconds.
> 10 s
4-1000 ms
T
www.bannerengineering.com - Tel: +1.763.544.3164
Result
> 1 cycle
Sensor returns to normal
operation.
> 1 cycle
T
Result
1. The green LED flashes
to show that the sensor
is in LO/DO select mode.
2. The amber LED indicates the selected
operation mode.
Light Operate
Dark Operate
3. The sensor is configured and returns to
normal operation.
VS8 Sensor Series
GREEN LED FLASHING
GREEN LED FLASHING
AMBER LED ON
GREEN LED FLASHING
AMBER LED OFF
11