Leica GM30 User Manual page 36

GR30/GM30/GR50, GR30/GM30 User Interface
Buttons
3 s
1 X
3 s
2 X
3 s
3 X
3 s
How to
• Press and hold the Function button until the LED flashes
quickly to START all configured logging sessions if the Raw
data logging LED is flashing green.
OR
If any logging session had been active, the Raw data logging
LED is flashing red.
• Press and hold the Function button until the LED flashes
quickly to STOP all active logging sessions if the Raw data
logging LED is flashing red.
After logging has been started or stopped, the LED and instru-
ment functionality goes back to general behaviour.
Start/Stop all data streams
Activate the dual button functionality.
Press the Function button once until the
streams LED starts flashing slowly.
If all data streams had been off, the RT out data stream LED is
flashing green.
• Press and hold the Function button until the LED flashes
quickly to START all configured data streams if the RT out
data steam LED is flashing green.
If any data stream had been active, the RT out data stream LED
is flashing red.
OR
• Press and hold the Function button until the LED flashes
quickly to STOP all active data streams if the RT out data
stream LED is flashing red.
After data streams have been started or stopped, the LED and
instrument functionality goes back to general behaviour.
Initialise the measurement engine
Activate the dual button functionality.
Press the Function button twice until the
flashing slowly.
• Press and hold the Function button until the LED flashes
quickly to reset the measurement engine. This action will
delete all almanac and ephemeris information and the
instrument will take a few minutes to restart tracking satel-
lites.
After the measurement engine has been initialised, the LED
and instrument functionality goes back to general behaviour.
Format receiver settings
Activate the dual button functionality.
Press the Function button three times until the
starts flashing slowly:
• Press and hold the Function button until the LED flashes
quickly to set all configured instrument settings back to
factory default values.
After the system format is completed, the LED and instrument
functionality goes back to general behaviour.
RT out data
Position LED starts
Power LED
36