General characteristics
General characteristics
Environmental
Conditions
Power supply
MTX 3281B
MTX 3282B
MTX 3283B
Endurance
Display
100,000-count graphical multimeters
Altitude
Reference temperature
Utilization temperature
Influence of temperature see §.
Relative humidity
Sealing
Operating range
Storage range
Battery charge range
2 possibilities:
Batteries
Accumulators
3 possibilities:
Batteries
Accumulators
Wall Plug power unit:
Mains voltage
Overvoltage category
Frequency
Via the wall plug, the accumulators can be recharged without removing them
from the multimeter.
Average charging period: 7h30 (with 2600 mAh accumulators)
with batteries
with 2200 mAh accumulators
In case of intermittent use of the multimeter, powering by Ni-MH cells is not
recommended: this type of cell has a self-discharge rate of 100 % after
3 months of non-use.
Endurances are reduced if the LCD backlight and/or the Bluetooth
communications interface is used."
Graphic LCD
Main display
Secondary display
< 2000 m
23° C ± 5° C
0° C to 55° C
Influence
Max 80% for temperature up to 31°C
Decreasing linearly to 50% at 40°C
Limited to 70% for the 50MΩ range
IP 51
- 10° C to 55° C
- 40° C to 70° C
0 to 40° C
3 x 1.5 V alkaline LR6-AM3 AA
3 x 1.2 V Ni-MH 2600 mAh AA
3 x 1.5 V alkaline LR6-AM3 AA
3 x 1.2 V Ni-MH 2600 mAh AA
230 V ± 10% or 110 V ± 10%
CAT II
45 Hz - 65 Hz
80 h (V
mode)
DC
approximately 65 h (V
useful part 58 x 58 mm
orientable, LED backlit, transflective
improvement of contrast in full light
100,000 points + sign + curve adaptive
units + bargraph (40 segments)
indicators of modes engaged
battery level indicator, dangerous voltage
indicator...
secondary functions with adapted units
mode)
DC
41