Pto Clutch Lever; Pto Clutch Lever - Kioti CS2610 Manual

Gauge wheels must be adjusted ac-
cording to the cutting height setting.
Use the following chart for gauge
wheel position.
FRONT and REAR
CuTTING HEIGHT GAuGE wHEEl
POSITION
(On control lever) (ground to center
66 mm (2.60 in.)
1.0"
78 mm (3.07 in.)
1.5"
91 mm (3.58 in.)
2.0"
104 mm (4.09 in.)
2.5"
97 mm (3.82 in.)
3.0"
109 mm (4.29 in.)
3.5"
102 mm (4.02 in.)
4.0"
M46-EU,AU-04.indd 23

PTO CluTCH lEvER

HEIGHT
of wheel)

(1) pTO Clutch Lever

(A) engage
To connect the selected pTO, move
the pTO clutch lever to the left, front
and then to the right.
To disengage the pTO clutch, move
the lever to the left and then rear.
To engage the pTO, move the pTO
shift lever to the desired position and
pTO clutch lever to the engagement
position.
desCrIpTION OF OperATING sysTeM
To change pTO selection, the

pTO clutch should be disen-
gaged. Also, it should be disen-
gaged when trying to start the
engine.
Most PTO devices gives the

M46O435A
most effective results when in
540 ± 10 rpm. The tachometer
(b) disengage
has a mark that indicates 540
rpm for effective PTO opera-
tion. Operating any PTO de-
vice in faster RPM can result
in poor efficiency and danger.
4
- 2
NOTE
IMPORTANT
4
2012-01-19 오후 1:48:48