Kioti CS2610 Manual page 49

(B)

When the key switch is in position
"B", the engine and all electrical
devices in the vehicle are turned
off.
However flasher lights and turn
signal lights can be operated along
with their indication lamps on the
dash board.
ACC (C)

When the key switch is turned
to the position "C", brake lights,
flasher lights and turn signal lights
can be operated.
(D)

The position "D" indicates the "ON"
position. As soon as the key switch
is turned to this position, the oil
pressure warning lamp and battery
charge warning lamp comes on.
(These turn off after the engine is
started)
M46-EU,AU-04.indd 5
NOTE
The pre-heating operation will

automatically be activated in this
position "D" (ON). The automatic
preheat operation is indicated
by the glow plug indicator. Make
sure to preheat the engine un-
til the glow plug indicator goes
off (approx. 6 seconds) in cold
weather before turning key switch
to start position.
Temp. Pre-heating and indicating time
T 40 0 sec
＞
-15 T 40 6 sec
＜ ＜
T ＜ -15 15 sec
(E)

The position "E" indicates "Start".
As soon as the engine is started,
release the key then the key will
return to the position "D".
DESCRIPTION OF OPERATING SYSTEM
IMPORTANT
To start the engine, place the

range shift lever in the neutral
position and PTO lever in the
OFF position. Then, sit on the
seat and turn the key switch to
the START position.
NOTE
Dashboard welcoming ceremony;
When the engine is started, the

backlight of the instrument clus-
ter comes on. Also, the pointer
on the tachometer moves from
0 to the full position and then
indicates the idling state. This is
not an electrical problem, but it
is called "dashboard welcoming
ceremony".
4
- 
4
2012-01-19 오후 3:28:13