Day/Night Mode - ABB i-bus KNX Product Manual

11.5.138.14

Day/Night mode

Options:
Deactivated:
■
– Communication object "Day/night mode" is not enabled.
Activated:
■
– Communication object "Day/night mode" is enabled.
– If a telegram with value "1" is received via the object, the button LEDs display light up
brightly. If a telegram with value "0" is received, the LEDs light up dark.
The LEDS of the RTC buttons can light up in two different brightness levels. The parameter is
used to specify whether the LEDs can be switched over between bright and dark.
Note
The parameter is available via the following settings:
■
■
■
■
The parameter is available also via the following settings:
■
■
■
The parameter is available also via the following settings:
■
■
Product manual 2CKA001473B9482
Description of application and parameters
Deactivated
Activated
The parameter is set on "Status illumination".
and
Parameter "Object type for status object" is set on "1 bit".
and
Parameter "Colour for Off" is set on a colour and not on "Off".
or
Parameter "Colour for On" is set on a colour and not on "Off".
The parameter "Operating mode" is set on "Status illumination".
and
Parameter "Object type for status object" is set on "1 byte 0-100%.
and
At least one parameter "Colour for zone x" is set on a colour and not on
"Off".
The Operating mode" parameter is set on "Function illumination".
and
Parameter "Colour for function illumination" is set on a colour and not on
"Off".
Application "Function block RTC"
│136