Programming The Rf System; Defaulting The Wireless Modules; Programming The Wireless Detectors - GE Security CS575 Installer Manual

5.4 Programming the RF system

RF Receiver 32
5.1
RF Receivers 33 - 39
Same as above

5.4.1 Defaulting the wireless modules

You must enroll and default each RF receiver before you begin programming the system.
You must default each module before you start programming it.
1. Navigate with the
2. Select the relevant module bus ID and press OK. In this case select RF Receiver 32 and press OK.
3. Select Default Settings and press OK.
4. A confirmation message is displayed. Press OK to accept the default settings.
5. The keypad sounder beeps once to confirm the reset.

5.4.2 Programming the wireless detectors

1. Navigate with the
2. Select the relevant module bus ID and press OK. In this case select RF Receiver 32 and press OK.
3. Scroll to Start Zone and press OK.
4. Enter the starting zone of the receiver. In this case, enter zone 9 to set zone 9 as the starting zone for receiver
32.
5. Scroll to Learn-in Mode and press OK.
6. To learn-in more than one device, scroll to Sequential Programming, select Yes and press OK.
CS875-575-375-275-175 Installers Manual with CS5500 keypad
Start Zone
5.1.1
Learn-in Mode Start Learning
5.1.2 5.1.2.1
Sequential Programming
5.1.2.2
Inputs Sensor 1
5.1.3 5.1.3.1
Sensors 2 - 168
Same as above
Range of sensors depends
on the number of sensors
and the start zone
number.
Receiver Features Jam Detection
5.1.4
5.1.4.1
Keyfob User ID
5.1.4.2
Keyfob Low Battery Reports*
5.1.4.3
Antenna Tamper**
5.1.4.4
Box Tamper**
5.1.4.5
* Disabled for 433 Mhz receivers
**Disabled for 868 Mhz receivers
Supervision
Normal Window
5.1.5 5.1.5.1
Short Window
5.1.5.2
Fire Window
5.1.5.3
RF Signal RSSI Check Zone*
5.1.6.1
5.1.6
RSSI Value*
5.1.6.2
Last Round Count**
5.1.6.3
* Disabled for 433 Mhz receivers
** Disabled for 868 Mhz receivers
Model
5.1.7
Version
5.1.8
Default Settings
5.1.9
keys to RF Receivers and press OK.
keys to RF Receivers and press OK.
(1) Zone 1
5.1.2.1.1
Enabled
5.1.3.1.1
Supervised
5.1.3.1.2
Fire Supervision
5.1.3.1.3
Keyfob
5.1.3.1.4 5.1.3.1.4.1
5.1.3.1.4.2
5.1.3.1.4.3
Door/Window*
5.1.3.1.5 5.1.3.1.5.1
5.1.3.1.5.2
*Disabled for 868 Mhz
receivers
Smoke*
5.1.3.1.6 5.1.3.1.6.1
*Disabled for 868 Mhz
receivers
Delete
5.1.3.1.7
Keyfob Funct 1
Keyfob Funct 2
Partitions
Internal Reed
External Contact
Tamper
B.5.6