Setting Up The Cs586; Overview; Connecting The Cs586 Direct Connect Module; Connecting The Cs586 To A Pc - GE Security CS575 Installer Manual

Chapter 8: Setting up the CS586

8.1 Overview

The CS586 direct connect module is an optional device used to interface the up/download software directly to
the control panel when the on board serial port is not available. The CS586 direct connect module has four
programming memories.

8.2 Connecting the CS586 direct connect module

8.2.1 Connecting the CS586 to a PC

1 RS232 connector
2 RJ11 (rear-entry connector)
3 Waiting for host communication LED
1. Connect the CS586 direct connect module to the serial port of the PC. The layout of the 25 PIN serial
connector on the PCB is:
2. Connect the cable to the CS586 direct connect module.
3. Using stripped wires, connect the cable with alligator clips to a CSx75 panel as follows:
• Red to POS
• Black to COM
• Green to DATA
CS875-575-375-275-175 Installers Manual with CS5500 keypad
5
6
1
Table 8-1: CS586 direct connect module serial connector
Sub
RXD
TXD
GND
4
3
D9
PIN 2
PIN 3
PIN 5
2
4 Waiting for bus communication LED
5 Sending data LED
6 Receiving data LED
D25
PIN 3
PIN 2
PIN 7
B.8.1