Linux Support For Es Devices; Configuring The Es Device From Linux; Using Cyclades Serial Client To Communicate With Es Device Ports - Brainboxes ES-357 Product Manual

18. Linux support for ES devices

The Ethernet2Serial can work in Linux but the drivers are not compatible, which means you cannot
use Boost.LAN. To use the device, you would have to open the port using the IP address. You can
configure the settings etc using the device webpage (by entering its IP address into your search bar).
It is possible to communicate with the ES range of devices from Linux for both configuration and
communicating with attached devices using standard serial port applications. This is achieved by
using the Cyclades Serial Client application.
NB the Cyclades Serial Client application is open source software, which is not owned or distributed
by Brainboxes. Brainboxes cannot be held responsible for any loss or damage incurred from using
this software.

Configuring the ES device from Linux

To configure the device, you will need to know the device's IP address. You should be able to
•
get this information from your network administrator. If this is not possible, you can search for
the ES device from a Linux machine using upnp_search.pl. This can be found on the CD in
the directory Product Support/Utilities/Linux Tools and requires Perl to be installed along
with the Net::UPnP Perl module.
Configuration of all the options on the device can be done using the Web page interface. This
•
can be done from any OS, using any modern browser (e.g Mozilla Firefox, Konqueror, Opera,
etc) See Section 10.
Note: The Cyclades Serial Client will not be able to track changes in the IP address of an ES
•
product on the network. It is for this reason that we recommend setting the device to a static
IP address on the ES device when used with Linux.

Using Cyclades Serial Client to communicate with ES device ports

The Cyclades serial client can be downloaded as an rpm, or can be installed from the
•
standard package repositories of many popular flavours of Linux, including Debian and
Ubuntu.
After installation, the correct details for the Brainboxes ES ports will need to be added to the
•
/etc/cyclades-devices file. You will require one configuration line for each port, which contains
the following details in a colon separated format;
devname
o
rastype
o
rasname
o
physport
o
type communications protocol. Set to rfc2217
o
options
o
ES Range Product Manual
the device node in /dev, e.g. /dev/ttyS0
this is just set to Brainboxes
the IP address of the ES device on your network
port number on the device
further device specific options –p 9000 –d 0
Version 2.9
© Copyright Brainboxes Limited 2013
Page 58 of 66