Terminal Block Connector Pin Out (Dependent On Es Model); Storage And Operating Environment Guidelines - Brainboxes ES-357 Product Manual

Terminal Block Connector Pin out (dependent on ES Model)

For ES devices with terminal block connectors have the signals detailed below.
i. RS-232 & RS-422/485 Port (e.g. ES-357)
Port screw terminal pin outs
ii. RS-232 1 Port (e.g. ES-020)
Port screw terminal pin outs
For RS-422 FULL Duplex Communications, please note the pin outs above.
To achieve RS-485 Half Duplex Communications on a terminal block, using two wires for
communication, you need to use the "Data" pins marked with D+/D-. E.g. for the ES-357 this would be
Pin 8 and Pin 9.
Once your wiring is setup, you will also need to set the device to FULL or HALF Duplex mode in the
software. For further details, see Section 9
iii. Power Terminal Block
Port screw terminal pin outs

Storage and Operating Environment Guidelines

Storage
Temperature: -10
Humidity: 8% to 95% non-condensing
Operational
o
Temperature: 0
Humidity: 20% to 75% non-condensing
ES Range Product Manual
RS-232
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
RS-232
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
o o
C to +70 C
o
C to +50 C
Version 2.9
© Copyright Brainboxes Limited 2013
RS-422/485
TxD Pin 6
RxD Pin 7
RTS Pin 8
CTS Pin 9
GND Pin 10
TxD Pin 6
RxD Pin 7
RTS Pin 8
CTS Pin 9
GND Pin 10
Pin 1 V+ Power Supply +
Pin 2 V- Power Supply -
Pin 3 Earth/Chassis Ground
TxD+
TxD-
RxD+/D+
RxD-/D-
GND
DTR
DSR
DCD
RI
GND
Page 63 of 66