Network Ip Addressing; Default Settings - Brainboxes ES-357 Product Manual

For information on power supplies and pin outs please see Section 20 Technical Specifications.
LED Information
Status LED
Serial Port LED
Ethernet LED

Network IP Addressing

The ES device is shipped in DHCP Mode.
On connecting to the network, the device automatically checks if it is connected to a DHCP
Server. If this is the case, the DHCP server will allocate an IP address automatically to the ES
device.
If no DHCP Server is detected (e.g. you have the ES device plugged directly into the PC), the
ES device will default to an IP address of 192.168.127.254 within 60 seconds. Please ensure
the PC you're using for configuration can communicate with the 192.168.127.xxx IP range by
setting the Ethernet port the ES device is plugged into, to an IP address in the same subnet.
If you are using the default IP address with no DHCP server, you can change to a static IP
address to avoid having to wait 60 seconds for the default address of 192.168.127.254

Default Settings

Device Network Address
Web Server Port
Baudrate
Databits
Stop bits
Parity
Flow Control
Duplex mode
Protocol Settings
ES Range Product Manual
Green Light On
Flashing Green
Flashing Red & Yellow
Flashing between Green & Red
Flashing between Green & Red
Flashing Green/Red
Flashing between Green & Yellow
Green light on
Flashing light on
Green light on
Flashing Green
Network Setting
DHCP Mode
80
RS-232 Port
115200
8
N
1
None
Full Duplex
Telnet + COM port control
Mode (Server)
Version 2.9
© Copyright Brainboxes Limited 2013
Device Ready
Changing Settings
Querying IP
IP Problem
Performing Hard Reset
Problem during initialization (e.g.
Firmware Problem)
Port Open
Data RX/TX
Link established
Data RX / TX
Port Settings
RS-422/485 Port
115200
8
N
1
None
Full Duplex
Telnet + COM port control Mode
(Server)
Page 9 of 66