Brainboxes ES-357 Product Manual page 39

5. Click the 'Apply Changes' button and you will be taken to a page which will display a success
page. You will be redirected to the port page after the countdown timer has finished.
6. The devices will now be in tunnelling mode.
7. On the Local device port webpage you will see displayed the device tunnelling section with
two buttons, 'Disconnect' and 'Stop Tunnelling'. By clicking the 'Stop Tunnelling' button this
will disconnect the ports on the remote and local side and put both of the devices into an idle
state. If the 'Disconnect' button is clicked the remote side port will be disconnected and go
into the idle state, but the local side will remain in tunnelling mode.
8. When the remote port is disconnected the local port webpage shows a 'Connect' button.
When this button is pressed the remote device will be connected to the local device and
tunnelling will be connected.
ES Range Product Manual
Version 2.9
© Copyright Brainboxes Limited 2013
Page 39 of 66