Ableton Live! + Sigma (With Mcu Control Surface); Using Sigma With Other Daws; Sigma Browser Settings - Solid State Logic Sigma User Manual

A L ! + S
bLeToN Ive
If you wish to use Ableton Live with a control surface such as Nucleus, you should configure it using the same instructions
as in the previous setup example ( Ableton Live! + Sigma). Be aware that Ableton does not support control surface
grouping, so using banking functions on your MCU controller will mis-align the automation streams Sigma receives.
U S
SING IGmA wITH oTHer
This mode will work for any DAW that supports MIDI channels with faders. It works by using MIDI tracks in your session
to control the analogue gains directly, rather than over the HUI/MCU protocols. This also means that if you have a control
surface, banking does not have any unwanted effects on the automation data.

Sigma browser Settings

1. Go to the Settings page in the Sigma browser.
2. Set DAw/ProToCoL to mIDI from the drop-down box.
3. Disable the HANDSHAkING button.
4. Go to the mIDI AbSoLUTe mode and pick an ipmIDI Port - e.g. Port 9.
Note that the CHANNELS 1-8 and CHANNELS 9-16 boxes have no effect when using MIDI.
(w mCU C
IGmA ITH
DAw
S
S
oNTroL UrFACe
Page 63
)