Logic Control Surface Settings - Solid State Logic Sigma User Manual

Logic Control Surface Settings

First, we'll set up Sigma.
1. Open Logic.
2. Go Preferences > Control Surfaces Setup...
3. Choose New and then Install...
4. Select a mackie Designs - mackie Control and click Add.
5. Set output Port and Input Port to Port 1.
6. Now select a mackie Designs – mackie Control extender from the list and click Add.
7. Set output Port and Input Port to Port 2.
Important: Please ensure you are selecting the Mackie Designs - Mackie Control Surface and NOT the Mackie Designs
- Logic Control Surface. The Logic Control Surface sends different messages and Sigma will not respond to these.
Now, we'll set up Nucleus for operation on DAW Layer 2:
3. Choose New and then Install...
4. Select a mackie Designs - mackie Control and click Add.
5. Set output Port and Input Port to Port 3.
6. Select a mackie Designs - mackie Control extender and click Add.
7. Set output Port and Input Port to Port 4.
8. This is the important part: When you have all the Mackie Controllers and Extenders in a line, highlight the last two
(Mackie Control #2 and Mackie Control Extender #2) and drag them underneath the first two controllers. Doing this
will create a different 'Control Surface Group'.
Page 48