2
Mounting
Topics covered in this chapter:
•
•
•
2.1
Mount the meter enclosure to a wall
Micro Motion recommends that you install the meter in an enclosure that is mounted to a
wall.
When you order the meter with an enclosure, the meter and pipework inside the enclosure
are configured at the factory to allow for easy installation of the meter in your process
pipeline.
Important
If you are installing the SGM as a stand-alone device (not inside an enclosure): for best performance,
you must ensure that the SGM is not exposed to rapid changes in temperature.
Figure 2-1:
A.
B.
Installation Manual
Mount the meter enclosure to a wall
Connect the gas bypass lines
Rotate the display on the transmitter (optional)
SGM installed in mounting enclosure
Stainless steel insulated enclosure (600 x 800 x 300 mm)
Stainless steel insulated enclosure (600 x 800 x 300 mm) with sample conditioning system
Mounting
7