Icom IC-M92D Instruction Manual page 44

Manual Reply:
Enter "POSITION REPLY" in the DSC CALLS menu.
q
• If no Position Request call has been received, the "POSITION
REPLY" item will not be displayed.
➪ DSC Calls
MENU
(Push [MENU]) (Push [Y]/[Z], then push [ENT].)
Select a desired Position Request call to reply to, using
w
[Y]/[Z], then push [ENT].
The Position Reply call confirmation screen is displayed.
e
Push [CALL] to transmit the acknowledgement call.
➪ Position Reply
While transmitting the reply call, the screen as shown be-
r
low is displayed, and then returns to the normal operating
mode.
When no GPS receiver is connected, and both position
and time have been manually programmed, the screen as
shown below appears. Edit your latitude and longitude posi-
tion and UTC time data as follows:
Push [CHG], then edit your latitude and longitude position
and UTC time data.
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT].
• Select N: North latitude or S: South latitude when the cursor
is on the 'N' or 'S' position.
• Select W: West longitude or E: East longitude when the cur-
sor is on the 'W' or 'E' position.
8
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
40