Additional Options - Automatic Technology iOpener RD40 Installation Instructions Manual

Additional Options

fi g 22
fi g 23
fi g 24
iOpener™ RD40
12
Owner Installation Instructions
Setting of Courtesy Light Time
The preset courtesy light time is three minutes.
This time can be changed by:
a. Press and hold both AUTO CLOSE TIME
and FORCE MARGIN SET (Fig. 22).
b. While holding
TO INCREASE - press the OPEN
button - each
10 seconds to
TO DECREASE - press the CLOSE
button - each press will deduct 10
seconds from the light time.
c. To recall the factory set light time press
and hold together the AUTO CLOSE
TIME with FORCE MARGIN SET and
SET for 2 seconds.
Setting the Pet Mode position
The default Pet Mode height can be changed
as follows:
a. Make sure the door is closed, then press
and hold the OPEN button for six (6)
seconds (Fig. 23), until you hear three
beeps and the OPEN and CLOSE LEDs
fl ash rapidly.
b. Press the OPEN or CLOSE button to
move the door to the desired pet mode
open position.
c. Press SET to record the new position.
When activated, Pet Mode drives the door to
a preset position from either above or below.
Pet Mode's active status is indicated by both
the OPEN and CLOSE LIMIT LEDs being
illuminated.
Reset all Factory Defaults
a. Turn power to opener off.
b. Press and hold the SET and DOOR CODE
(Fig 24).
c. Turn power on while holding the SET
button. Continue to hold until all LEDs
are off.
in these buttons:
press will add
the light time.