When A Message Is Displayed On The Client Computer - Ricoh 9016 Troubleshooting Manual

Troubleshooting When Using the Scanner Function
Message
Out of paper.
Set paper on the
tray.
Check the reso-
lution and reset
nnn origi-
nal(s).
(A figure is placed at
nnn.)
Exceeded max.
data capacity
Check resolu-
tion and Start.
5
Exceeded max.
page capacity.
Do you want to
send the scanned
data?

When a Message Is Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error
messages displayed on the client computer when using the TWAIN driver.
Important
❒ If an error message that is not included in this section appears, turn off the
main power switch of the machine, and then turn it on again. For information
about how to turn off the main power switch, see "Turning Off the Main Pow-
er", About This Machine.
Message
Clear Mis-
feed(s) in ADF.
Invalid Winsock
version. Please
use version 1.1
or higher.
The name is al-
ready in use.
Check the regis-
tered names.
60
Cause
No paper is loaded in the speci-
fied paper tray.
The scanned original exceeded
maximum data capacity.
The scanned data exceeded maxi-
mum data capacity.
The number of scanned pages ex-
ceeded maximum page capacity.
Cause
A paper misfeed has occurred in-
side the ADF or ARDF.
You are using an invalid version
of Winsock.
You tried to register a name that
is already in use.
Solution
Load paper of a size that is listed
in the message.
Specify the scan size and resolu-
tion again. Note that it may not be
possible to scan very large origi-
nals at a high resolution. See "Re-
lationship between Resolution
and Scan Size", Scanner Refer-
ence.
Specify the scan size and resolu-
tion again. Note that it may not be
possible to scan very large origi-
nals at a high resolution. See "Re-
lationship between Resolution
and Scan Size", Scanner Refer-
ence.
Select whether to send the data so
far.
Solution
Remove jammed originals, and
place them again.
Check whether the originals are suit-
able to be scanned by the machine.
Install the operating system of the
computer or copy Winsock from
the operating system CD-ROM.
Use another name.