Table of Contents
Advertisement
Troubleshooting
Messages/Second messages
Hardware Problem Finisher
Hardware Problem HDD
Hardware Problem IEEE1394
4
72
Description
There is a problem with the
finisher.
The printer identified a HDD
Board error.
The printer identified an
IEEE1394 Board error.
Solution
Turn the power switch off and
then on. If the message ap-
pears again, contact your sales
or service representative.
Remove and re-install the
HDD Board correctly.
If the message appears again,
contact your sales or service
representative.
See "Setting Up" in the Setup
Guide.
Remove and re-install the
IEEE1394 Board correctly.
A
Confirm that the 1394 In-
terface Unit Type1045 is
attached to the computer
correctly.
B
Confirm that the IEEE1394
interface cable is connect-
ed securely.
C
Unplug the IEEE1394 in-
terface cable which is con-
nected to the printer.
D
Restart the computer.
If the message appears
again even after executing
above operation, proceed
to the following steps.
E
Execute the utility tool for
1394 Interface Unit
Type1045 which is stored
in the following path in the
CD-ROM labeled "Printer
Drivers and Utilities".
UTILITY\1394
Important
❒ For details about using
the utility tool for
IEEE1394, see the RE-
ADME file in the same
directory in the CD-
ROM.
If the message appears again,
contact your sales or service
representative.
See "Setting Up" in the Setup
Guide.
Advertisement
Table of Contents
