Supported Pre2 Wan Slot Configurations - Cisco uBR10012 Hardware Installation Manual

Overview of SPA Interface Processors
• For a PRE2 configuration with the Cisco 5-Port Gigabit Ethernet SPA, total bandwidth of GE ports per

Supported PRE2 WAN Slot Configurations

This section provides details about the possible WAN slot configurations supported on a Cisco uBR10012
router with a PRE2 setup. Each table lists the SIP or half-height line card type that can be inserted in each
pair of WAN slots (1 and 2, or 3 and 4). In the case of a SIP, the table also lists the combination of SPAs that
can be placed in the SIP.
Cisco 10000 Series SPA Interface Processor-600 bays 0 and 2, and 1 and 3 share ironbus resources.
Note
The table below lists details of the WAN slot configuration with the Cisco Wideband SIP and an HHGE.
Table 15: PRE2 Configuration Sample A
Slots
1 and 2
3 and 4
The table below lists details of the WAN slot configuration with the Cisco 10000 Series SPA Interface
Processor-600 and an HHGE.
SPA should be limited to 2Gbps. If more than two GE ports are enabled, total inbound or outbound
aggregate bandwidth should be kept at 2Gbps. If the bandwidth exceeds 2Gbps, the support for Quality
of Service (QoS) functionality cannot be guaranteed.
SIP
Cisco Wideband SIP
Half-Height
Cisco uBR10012 Universal Broadband Router SIP and SPA Hardware Installation Guide
Supported PRE2 WAN Slot Configurations
SPAs/HHGE cards Maximum Cards
Supported
Up to two
• Cisco Wideband
Cisco Wideband SPAs.
SPA
• Cisco Wideband
SPA (optional)
Up to four HHGEs.
• HHGE
• HHGE (optional)
• HHGE (optional)
• HHGE (optional)
19