Supported Cisco Antennas And Cables - Cisco IR809 Product Overview

Integrated services routers

Hide thumbs Also See for IR809:

Product Overview

• External Reset/Recovery Push Button

• WWAN Modem

• WAN Ports

• Serial Ports

• USB Ports

• Compliance

Reset Button

The Reset button resets the router configuration to the default configuration set by the factory. To restore the

router configuration to the default configuration set by the factory, use a standard size #1 paper clip with wire

gauge 0.033 inch or smaller and simultaneously press the reset button while applying power to the router.

The reset button works in two different manners:

• With the reset button pressed for less than 10 seconds, the IR809 will load with saved start-up configuration

• With the reset button pressed longer than 10 seconds, the NVRAM file system is erased and the IR809

Supported Cisco Antennas and Cables

The Cisco IR809 ships without antennas. All antennas are options that can be ordered separately.

• 4-pin 3.8 mm EURO power connector

• 1x internal Mini PCIe slot for Single multi-band 2G/3G/4G/LTE cellular modem

• Dual USIM Card slots (2 external SIM card slots). Provides Redundancy and multi-homing

capabilities over LTE and HSPA-based networks.

• 2x RJ45 10/100/1000 Gigabit Ethernet

• 1 x RJ45 RS232 DTE Port

• 1 x RJ45 RS232/RS485 DCE Port (SW-configurable)

• 1x USB2.0 Type A External Host Port

• 1x USB2.0 Type Mini-B External Debug/Console Device Port

• Telcordia GR-3108 Class 2 deployment

• Class A EMC or better

• RoHS6

• IP30 compliant when vertical, IP40 compliant when mounted flat on a horizontal surface

at that time.

boots up with Initial Configuration.

Supported Cisco Antennas and Cables

Product Overview

Table of Contents