Cisco uBR10012 Hardware Installation Manual page 86

Universal broadband router sip and spa

Hide thumbs Also See for uBR10012:

Table of Contents

Installing a SPA in a SIP

Step 7

Tighten the two captive installation screws on each SPA with a torque screw driver using the sequence shown

in the figure below. The torque recommendation is 5 to 10 lb-in.

Figure 22: SPA in the Slot (Vertical Orientation)

Note

Step 8

Install the interface cables. We recommend that you clean the fiber-optic connections before attaching the

cables. See the

Cisco uBR10012 Universal Broadband Router SIP and SPA Hardware Installation Guide

Bottom captive installation screw

Before running any SW, make sure that all captive screws in all SPA cards have been tightened. If

there is any connection issue, re-seat the SPA.

Inspection and Cleaning Procedures for Fiber-Optic Connections

Installing and Removing a Shared Port Adapter

Top captive installation screw

document.

Table of Contents