Sm/Lcm Sensors And Indicators - Cisco GS7000 Installation And Operation Manual

Chapter 4 Troubleshooting

SM/LCM Sensors and Indicators

The SM/LCM housing contains a sensor and two indicators which provide the same
indications whether the module is a local control module or a full status monitor.
Note: Refer to Status Monitor/Local Control Module Description (on page 6) for an
illustration of the housing and indicators.
The functions of the sensor and indicators are described in the following table.
LED
LIGHT SENSOR
COND
(Green LED)
STATUS
(Red LED)
34
Indication
This ambient light sensor sends a trap to the status monitoring
and control software indicating that the node housing is open.
BLINK (slow) - Blinks approximately once a second if the
module receives the correct input power voltage.
OFF - Normal operation.
BLINK (slow) - Minor alarm. One or more of the measured
parameters is over threshold limit. Blinks approximately once
per second.
FLASH (fast) - Redundancy is ON. One or both of the primary
optical receivers has failed and the secondary receivers are now
operating. Flashes approximately two/three times per second.
ON (solid) - 1x/2x Fwd Seg: Redundancy has failed. One or
both of the primary optical receivers has failed and the
secondary receivers are also not operating. 3x and 4x Fwd Seg:
A receiver has failed.
4022871 Rev C