Closing The Housing - Cisco GS7000 Installation And Operation Manual

Gainmaker node seg2way status monitor/local control module

Hide thumbs Also See for GS7000:

Table of Contents

Tighten the module hold-down screws to secure the module in the lid. Torque

the screws from 25 to 30 in-lbs (2.8 to 3.4 Nm).

Closing the Housing

Close the housing as follows.

Ensure any worn gaskets are replaced, and the gaskets are clean and in the

correct position.

Carefully close the lid.

For strand-mounted housings, pull the lid away from the base and remove the

slack from the hinge before rotating the lid up toward the base.

Ensure no cables are pinched between lid and base.

Secure lid to base with bolts. Tighten from 5 to 12 ft-lbs (6.8 to 16.3 Nm) in the

sequence shown in the following illustration. Repeat the sequence twice, ending

with the final torque specification.

4022871 Rev C

CAUTION:

Use caution when closing housing. Improper closing may result in the Model

GS7000 Node not being sealed from the environment.

Installing the SM/LCM

Table of Contents