Connect Through Vpn; Vpn Connection Settings - Cisco 8941 User Manual

Connect Through VPN

Connect Through VPN
Procedure
Step 1
After you turn on your phone and the VPN Sign In screen appears (except with certificate authentication
mode), enter your credentials based on the configured authentication method:
• Username and password: Enter the username and the password that your system administrator gave you.
• Certificate and password: Enter the password that your system administrator gave you. Your username
• Certificate: If the phone uses only a certificate for authentication, the Sign In screen does not appear,
When the power is lost or reset under some circumstances, the stored credentials are cleared.
Step 2 Select Sign In to connect.
If you press Cancel while the phone is attempting the connection, the connection attempt stops, and the Sign
In screen appears again. If you press Cancel again, the VPN menu appears and shows the VPN Enabled field
as Off. The phone will not attempt a VPN connection again until you set the VPN Enabled field to On.

VPN Connection Settings

The VPN window (Applications > VPN) consists of these fields:
• Enable or disable VPN: If Auto-Detect Network Connection is disabled, toggle the VPN Enabled field
• Change credentials: Select Change Credentials to change the user ID and password. If the authentication
• View VPN status: The VPN Status field displays Connected or Not Connected.
Cisco Unified IP Phones 8941 and 8945 User Guide for Cisco Unified Communications Manager 9.0 (SCCP and
SIP)
28
is derived from the certificate.
and phone displays the status of the phone attempting the VPN connection.
to control the ability of the phone to attempt a VPN connection.
is certificate-only or VPN Enabled is Off, the option is dimmed.
Phone Applications