Digital Trimmer; Bm 3003 Setup - RCF MZ 8060 User Manual

DIGITAL TRIMMER

The digital trimmer adjusts the audio input sensitivity.
It can help optimize a too low or too high audio signal.
To access the digital trimmer (of a single input), click EDIT on the respective channel and
select the DSP window.
Set the DIG. TRIM fader to either a positive value to increase the input sensitivity or a
negative value to attenuate (0 dB: no change).
Use this fader with caution, in order to avoid signal distortion (too high) or an insufficient
level.

BM 3003 SETUP

To access the (common) BM 3003 paging microphone settings, click EDIT of the INPUT 1
and select the DSP window.
Each of the three BM 3003 paging microphone zone buttons corresponds to a checkbox
group: A ZONE, B ZONE and C ZONE.
Each BM 3003 zone button can be assigned to one or more buses (that correspond to
MZ 8060 audio outputs A to F) of both MASTER unit and SLAVE unit (if available).
Click ENABLE when using BM 3003 paging microphones. In the main
windows, the INPUT 1 (MASTER) red BMC lights up.
22
DIGITAL TRIMMER
BM 3003 SETUP