How To Link Two Mz 8060 Each Other; Notes About The Rdnet Software - RCF MZ 8060 User Manual

21
REM-CTRL REM-CTRL RS 485 serial port for remote control via third-party software
(removable connector).
GND
P
N
V
22
Input for the power cord (to be connected to mains through an earthed socket only).
Two MZ 8060 can be linked each other to get a 16-input 12-output matrix
through the EXTENSION LINK ports (RJ 45 sockets) on their rear panels.
Connect the EXTENSION LINK OUT
EXTENSION LINK IN 14 input of the second MZ 8060 and vice-versa.
T
he Two cables musT be unshielded
( 8 ).
abouT inches
w Pc (
hen using The sofTware read The resPecTive manual secTion
> u s '),
configuraTion niT eTTings
mZ 8060 slave.
second To
The RDNET software is protected by international copyright laws and is to be used to
configure the RCF RDNET system only.
It is not allowed to modify or change or try to decompile this software.
In no event shall RCF S.p.A. be liable to end-users for any damage whatsoever, including
but not limited to financial damages for loss of business profits or business information
due to the software use or inability to use this product.
The foregoing provision is effective even if RCF S.p.A. has been advised of the possibility
of such damages.
Even if the SOFTWARE has any material, verifiable and reproducible program errors, RCF
S.p.A. shall have no obligation to modify such errors.
Ground
Non-inverting pin (RS 485 A)
Inverting pin (RS 485 B)
24 V dc

HOW TO LINK TWO MZ 8060 EACH OTHER

15
output of the first MZ 8060 to the
caT 6 20
and noT longer Than
mZ 8060 masTer
seT The firsT To

NOTES ABOUT THE RDNET SOFTWARE

cm
's
ofTware
and The
EXTENSION LINK
OUT
MZ 8060 (1)
IN
FROM / TO MZ 8060
EXTENSION LINK
OUT
MZ 8060 (2)
IN
FROM / TO MZ 8060
11