Wiring; Specialty Fan Wiring - Thermostat (Robert Shaw) - QuietCool GA ES-1500 Owner's Manual

3. WIRING

NOTE: Wiring Diagrams are for examples ONLY. Wiring should be done by an experienced
electrician.
NOTE: Your fan may have come with the thermostat pre-wired to a power cord. If this is the
case, simply mount the thermostat or junction box, find a power source in your attic, and plug
the fan in. If you would like to hard-wire the fan, or it is required by your local building codes,
please follow the wiring instructions below.
3.1 Specialty Fan Wiring - Thermostat (GA ES-1500, GX ES-1100)
For wiring of a Specialty Series Fan with a Robert Shaw thermostat. This wiring method works with our GA ES-1500,
GX ES-1100, & RM models but we do not recommend using it with a RM model fan that is being used as a whole
house fan. (See 3.3A wiring diagram on page 14)
1. Mount a junction box for your thermostat in the best location for thermostat readings which is usually on
the wall next to the light switch or garage door opener in the garage. Begin wiring the thermostat.
2. With a 3 wire Romex, tie the black wire to the black wire from the thermostat.
3. Tape the white common wire on both sides of the 3 wire Romex because we will be using this as our switch
leg.
4. Tie the red wire and the taped white wire together.
5. Attach the ground wire to the ground screw on the timer.
Figure 3.3A
Specialty Series Fan Specialty Series Fan
Power Power
Source Source
6
Ground the fan to the junction box Ground the fan to the junction box
using the green ground screw using the green ground screw
Junction Junction
Box Box
14-2 Wire 14-2 Wire
14-2 Wire 14-2 Wire
50 50 60 60 70 70 80 80 90 90
OFF OFF
QUIETCOOLSYSTEMS.COM