Installing The Radio - Tait TM8100 Installation Manual

2.8

Installing the Radio

24 Installing the Radio
1. Connect the antenna cable, power cable, and—if applicable—the
auxiliary cable to the rear of the radio.
2. Position the radio in the U-bracket so that the holes in the U-bracket
line up with the holes in the radio chassis.
3. Screw the radio into position using the four thumb screws provided,
but without fully tightening the screws.
4. Adjust the position of the radio in the U-bracket for the best viewing
angle, then tighten the thumb screws.
Figure 2.6 Installing the radio in the U-bracket
TM8100/TM8200 Installation Guide
© Tait Electronics Limited July 2006