Tait TM8100 Installation Manual page 13

Removing the
Control Head
TM8100/TM8200 Installation Guide
© Tait Electronics Limited July 2006
Figure 2.1 Mounting the control head
1. Plug the control-head loom onto the control-head connector.
2. Insert the bottom edge of the control head onto the two clips in the
front of the radio body, then snap into place.
Important
During this procedure, take care that the control-head seal
is not damaged. Damage to this seal reduces
environmental protection.
Figure 2.2 Removing the control head
On the underside of the radio, two lever points are indicated on the radio
body by a dot-dash-dot pattern (
control-head seal and the control head.
1. At either of the lever points, insert a 5 mm (3/16 inch) flat-bladed
screwdriver between the control head and the control-head seal.
2. Use the screwdriver to lift the control head off the chassis clip, then
repeat in the other position. The control head can now be removed
from the radio body.
). The lever point is between the
Installing the Radio
control head
lever point
control-head
seal
indication of
lever point
13