Operating from the Cab Operating Panel (COP) Controls
1 If equipped with a key switch, insert the key into the key switch on the Cab
Operating Panel and turn the key to the ON position.
2 Press the selected Landing button once and release. The elevator will
automatically travel to and stop at the selected landing.
3 Turn the key (if equipped) to the OFF position and remove the key.
4 Unlock the wheelchair wheels (if applicable) and exit the cab.
If the cab is equipped with a gate, the gate must be closed after
exiting the cab. If the gate is left open, all controls will remain
inoperable.
The outside landing door must be closed after exiting or entering
the cab. If the outside landing door is left open, all controls will
remain inoperable.
Cab Lights
If the cab door is left open and the cab lights turn off, there are two ways to get
the lights back on again:
•
Enter the cab, close the door and gate and then press a Landing
button.
•
Press a Hall Call button before entering the cab.
Part No. 000841, 12-m01-2018
NOTE
Eclipse (Micro-6) Owner's Manual
11