Diagnostics - Savaria Eclipse Owner's Manual

8. DIAGNOSTICS

Diagnostic beep codes are provided on the Hall Calls to help you diagnose a
problem. All beep codes that begin with a long beep (on for 2 seconds) are
Service codes (contact your authorized Savaria dealer).
If you press a Hall Call button and it beeps but the car doesn't move, refer to the
information in the following table.
Beep code
Service codes
1 long beep (2 seconds) followed by
1 short beep (1/2 second)
1 long beep (2 seconds) followed by
2 short beeps (1/2 second)
1 long beep (2 seconds) followed by
3 short beeps (1/2 second)
User codes
1 short beep
(1/2 second)
2 short beeps
(1/2 second)
3 short beeps
(1/2 second)
Part No. 000841, 12-m01-2018
Action to take
Contact your authorized Savaria dealer
for service. There is a problem in one of
the following areas: overload trip, run
timer trip, main safety chain open, door
lock fault, or auto shutdown counter.
Contact your authorized Savaria dealer
for service. There is a problem with
re-level shutdown or the low pressure
switch is activated.
Contact your authorized Savaria dealer
for service. There is a selector fault,
selector encoding error, or position
error.
Make sure the "Stop" switch in the car in
the Run position.
Check that the car gate is closed.
Check that the landing door is closed.
Manually open and close the gate.
Eclipse (Micro-6) Owner's Manual
13