HP A5830 Series Configuration Manual page 56

Configuration procedure
NOTE:
This example assumes that the RADIUS server runs iMC PLAT 5.0 (E0101) and iMC UAM 5.0 (E0101).
Configure the RADIUS server (iMC PLAT 5.0).
1.
# Add an access device.
Log in to the iMC management platform, click the Service tab, and select User Access Manager > Access
Device from the navigation tree to enter the Access Device page. Then, click Add to enter the Add Access
Device window, and perform the following configurations as shown in
Set the shared key for authentication and accounting to expert.
a.
Specify the ports for authentication and accounting as 1812 and 1813, respectively.
b.
Select Device Management Service as the service type.
c.
Select HP(A-Series) as the access device type.
d.
Select the switch from the device list or manually add the switch with the IP address of
e.
10.1.1.2.
Click OK to finish the operation.
f.
The IP address of the access device specified here must be the same as the source IP address of the
RADIUS packets sent from the switch (which is the IP address of the outbound interface by default) or the
IP address specified with the nas-ip or radius nas-ip command on the switch.
Figure 13 Add an access device
# Add a user for device management.
Log in to the iMC management platform, click the User tab, and select Device Management User from
the navigation tree to enter the Device Management User page. Then, click Add to enter the Add Device
Management User window, and perform the following configurations as shown in
Add a user named hello@bbb and specify the password.
a.
Select SSH as the service type.
b.
Set the EXEC privilege level to 3. This value identifies the privilege level of the SSH user after
c.
login and defaults to 0.
Specify the IP address range of the hosts to be managed as 10.1.1.0 to 10.1.1.255.
d.
48
Figure 13:
Figure 14: