HP A5830 Series Configuration Manual page 125

Figure 40 Network diagram for configuring the autoLearn mode
Configuration procedure
Configure port security.
1.
# Enable port security.
<Device> system-view
[Device] port-security enable
# Set the sticky MAC aging timer to 30 minutes.
[Device] port-security timer autolearn aging 30
# Enable intrusion protection traps on port GigabitEthernet 1/0/1.
[Device] port-security trap intrusion
[Device] interface gigabitethernet 1/0/1
# Set port security's limit on the number of MAC addresses to 64 on the port.
[Device-GigabitEthernet1/0/1] port-security max-mac-count 64
# Set the port security mode to autoLearn.
[Device-GigabitEthernet1/0/1] port-security port-mode autolearn
# Configure the port to be silent for 30 seconds after the intrusion protection feature is triggered.
[Device-GigabitEthernet1/0/1] port-security intrusion-mode disableport-temporarily
[Device-GigabitEthernet1/0/1] quit
[Device] port-security timer disableport 30
Verify the configuration.
2.
After completing the configurations, use the following command to view the port security configuration
information:
<Device> display port-security interface gigabitethernet 1/0/1
Equipment port-security is enabled
Intrusion trap is enabled
AutoLearn aging time is 30 minutes
Disableport Timeout: 30s
OUI value:
GigabitEthernet1/0/1 is link-up
Port mode is autoLearn
NeedToKnow mode is disabled
Intrusion Protection mode is DisablePortTemporarily
Max MAC address number is 64
Stored MAC address number is 0
Authorization is permitted
117