Ssl Configuration Task List; Configuring An Ssl Server Policy; Configuration Prerequisites; Configuration Procedure - HP A5830 Series Configuration Manual

Figure 64 SSL protocol stack
SSL record protocol—Fragments data to be transmitted, computes and adds MAC to the data, and
•
encrypts the data before transmitting it to the peer end.
SSL handshake protocol—Negotiates the cipher suite to be used for secure communication
•
(including the symmetric encryption algorithm, key exchange algorithm, and MAC algorithm),
securely exchanges the key between the server and client, and implements identity authentication of
the server and client. Through the SSL handshake protocol, a session is established between a client
and the server. A session consists of a set of parameters, including the session ID, peer certificate,
cipher suite, and master secret.
SSL change cipher spec protocol—Used for notification between the client and the server that the
•
subsequent packets are to be protected and transmitted based on the newly negotiated cipher suite
and key.
SSL alert protocol—Enables the SSL client and server to send alert messages to each other. An alert
•
message contains the alert severity level and a description.

SSL configuration task list

Task

Configuring an SSL server policy

Configuring an SSL client policy
Configuring an SSL server policy
An SSL server policy is a set of SSL parameters for a server to use when booting up. An SSL server policy
takes effect only after it is associated with an application layer protocol, such as HTTP.

Configuration prerequisites

Configure the PKI domain for the SSL server policy to use to obtain a certificate for the SSL server. For
more information about PKI domain configuration, see

Configuration procedure

To configure an SSL server policy:
To do...
1. Enter system view.
Remarks
Required
Optional
"Configuring
Use the command...
system-view
201
PKI."
Remarks
—