5.3 When the Operation of the Emulator is Abnormal
Self-check is a function to check the memory etc. mounted in the emulator. Self-check is executed
when the emulator starts up, and detailed check is executed by following the procedure below.
For this self-check, be sure to disconnect the target system.
(1) Self-check Procedure in the Self-check Mode
Figure 5.2 Self-check procedure
POWER
CLOCK
RESET
LED2
LED3
LED4
POWER
CLOCK
RESET
LED2
LED3
LED4
(2) Target status LEDs repeat blinking
simultaneously.
POWER
CLOCK
RESET
LED2
LED3
LED4
(4) Target status LEDs repeat blinking in
succession.
About
30 seconds
[When self-checks terminated normally]
POWER
CLOCK
RESET
LED2
LED3
LED4
For starting up the emulator after self-check, shut
off the power of the emulator and reactivate it.
RUN
(1) Within 2 seconds of activating power to the
emulator, press the RESET switch.
LED5
RUN
(3) Press the system reset switch again after
checking target status LEDs blink.
LED5
RUN
LED5
[When error detected]
POWER
LED2
One or more target status LEDs repeat blinking
according to the error type.
RUN
LED5
( 44 / 52 )
CLOCK
RESET
RUN
LED3
LED4
LED5
LED display
ON
Blinking
OFF