Led Display When The Emulator Starts Up Normally - Renesas Compact Emulator M30620T-CPE User Manual

(3) LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is
enabled or not.
Target status LED
System status LED
Figure 2.10 Positions of system status LED and target status LEDs
(1) System status LED
Check the LED1 of the system status LED is lit immediately after the power is activated. If it is
not lit, shut off the power for the emulator and check the power supply for the emulator is properly
connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.11 when the target system is not connected and as
shown in Figure 2.12 when a target system is connected. For approximately the first 7 seconds
after power is turned on, all target status LEDs light. After that, check the LEDs light up as shown
in the figures.
If the target status LEDs do not light as shown in Figures 2.11 and 2.12, see "5.1 Troubleshooting
Until the Emulator Starts Up" (page 40).
Without target:
When the target is not connected, the
POWER LED is not lit.
: ON
: OFF
Figure 2.11 LED display when the emulator starts up normally (target system is not connected)
With target:
When the POWER LED is not lit, shut off
the power of the system and check the
setting of MCU power supply selection
jumper switch and if the power is properly
supplied to the target system.
: ON
: OFF
Figure 2.12 LED display when the emulator does not start up normally (target system is connected)
POWER
LED2
POWER
LED2
( 24 / 52 )
RESET
CLOCK RUN
LED3 LED4 LED5
RESET
CLOCK RUN
LED3 LED4 LED5