Maintenance - Billy Goat SC181HEU Owner's Manual

Maintenance Continued
Cable Control Adjustment
To adjust the cables place the machine on flat ground, switch off
the engine and disconnect the wire from the spark plug.
Blade and Drive Control Cables
Adjustments to the tension on the cables are made by adjusting
the barrel length located on the handle. By extending the barrel
out, more tension will be put on the cable. Make sure that you do
INCREASE
not apply too much tension as this will cause premature failure or
cause the lever to engage when it is not wanted.
Note: Apply lithium grease to the slots on the drive levers where
the cable sits to avoid premature failure. DECREASE
Part No. 373507EN Form No. F062317A
13