Advertisement
5. Hardware Configuration of the M30262T-PTC (See Figure 3)
Hardware configuration of the M30262T-PTC is shown below.
(1) Connector
Connector for the emulator for M16C/62P (M3062PT-EPB).
(2) Cable
Flat cable which connects the user system flexibly (Length: 150 mm).
(3) Target interface
Interface which has a connector for a user system and jumper switch JP1.
40b
J1
1b
Figure 3 Hardware configuration of the M30262T-PTC
6. Connection Procedure (see Figure 4)
The procedure for connecting the M30262T-PTC is shown below.
(1) Mount the NQPACK048SD.
(2) Mount the YQPACK048SD on the NQPACK048SD.
(3) Secure the four corners of the YQPACK048SD with
the YQ-GUIDE's.
Do NOT use the screws in the YQPACK048SD package.
Do NOT use the screwdriver in the NQPACK048SD
package for securing YQ-GUIDE's (used for securing
HQPACK048SD).
(4) Attach the M30262T-PTC to the YQPACK048SD.
(5) Connect the emulator for M16C/62P to the M30262T-PTC.
7. Switch Settings
When you use No. 36 pin (Port P1
set switch JP1 according to port functions.
For ADTRG
JP1
Figure 5 JP1 Settings
M16C/62P TOOL SIDE
40b
40a
40a
J2
1a
1b
1a
M30262T-PTCB REV.A
Connector
/INT
/ADTRG),
5
3
For P15 or INT3
JP1
Cable (FFC cable : 150 mm)
( PC7501 + M3062PT-EPB )
Figure 4 Connection Procedure
( 3/4 )
Jumper switch JP1
JP1
IC1
1
M30262T-PTC REV.A
Target interface
Emulator for 16C/62P
( PC4701 + M3062PT3-RPD-E )
PC7501
M3062PT-EPB
M3062PT3-RPD-E
(5)
(4)
YQ-GUIDE's
(x4)
M30262T-PTCB
YQPACK048SD
(2)
NQPACK048SD
(1)
48-pin 0.5-mm-pitch
(48P6Q-A) foot pattern
Use a flat-blade
screwdriver.
(3)
Advertisement
