Christie DHD599-GS User Manual page 61

Panel Description
SNMP Panel Provides network administrators with a common way to manage their network devices from a
single remote location. Administrators can use the Simple Network Management Protocol (SNMP)
interface to query a number of devices to see their current status or configuration. Operators can
change configuration values and configure trap notifications to be sent when certain events occur
(for example, loss of signal, power state change, and so on).
Emails are sent to the mail server configured in the projector settings. Up to two user email
accounts can be selected. Important information regarding the event is located in the body
content of the email.
SNMP Traps are notifications that are sent from the projector. They are only received by a trap
receiver (MIB Browser) in the computer.
• SNMP Read Community (default setting: private)—Plain text password that must also be
entered in the MIB browser. This password allows various settings in the projector to be
queried.
• SNMP Location (default setting: blank)—Use as a description to where a projector is located in
a building. SNMP emails sent specify this location.
• Trap IP Address (default setting: 0.0.0.0)—Fill in this field with the IP address of the computer,
on which you want to view received traps from the projector.
• Trap Email 1/2 (default setting: Blank)—Set the Trap Email 1 and 2 to an email address
configured under the mail server entered in the SMTP Server IP Address field.
• Email from Address (default setting: blank)—Set the name of the source of the SNMP emails.
• SMTP Server IP Address (default setting: 0.0.0.0)—Enter the IP address of the mail server.
Trap Set the SNMP actions for the system events. The options are:
Configuration
• SNMP Trap
Panel
• + Email
• Email
• SNMP Trap
• Disabled
Crestron Enter the IP address, IP ID, and port of Crestron device for the connection.
Control System
Panel
GS Series (DHD599-GS, DWU599-GS) User Manual
020-001162-0 Rev. 1 (12-2017)
Operation
61