Start Typing Commands - TDK-Lambda GENESYS User Manual

Usb interface

Hide thumbs Also See for GENESYS:

Table of Contents

7.7. Start Typing Commands

When the USB connection is made, the communication program is set up, and the power supply address

is known, then you may begin typing commands to the power supply and reading the responses.

The command set is described in detail in the Genesys™ User Manual.

A sample remote programming session is shown below. The power supply is set to deliver up to 5.0 volts

and 100 amps. It has measured the actual output to be 5.0015 volts. No fault conditions are reported.

NOTE

Before you can send any commands to the Genesys™ USB

ADR nn

power supply, you must send the address command

and an "OK" response must be returned.

83-033-800 Rev A

Table of Contents

Do you have a question about the GENESYS and is the answer not in the manual?