Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet FREEDOM FLEX H4 IP User Manual

Operation

IRC-6 Infrared Remote Control

The Freedom Flex H4 IP is compatible with the IRC-6 infrared remote control from Chauvet. To activate IR
mode, follow the instructions below.
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER> to accept.
3. Press <UP> or <DOWN> to select ON or OFF.
4. Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
To select only fading programs:
To adjust the speed of the automatic program:
Manual Color Control
To select a preset static color with the IRC-6:
To custom-mix a color with the IRC-6:
Strobe
To adjust the strobe rate:
Dimmer
To adjust the total output with the IRC-6:
Black Out
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
You may have inadvertently activated Black Out.
Freedom Flex H4 IP X6 User Manual Rev. 2
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the different auto programs.
1. Press <FADE> on the IRC-6.
2. Press <+> or <–> to choose between the different fading programs.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed of the program.
1. Press <1>–<9> on the IRC-6.
1. Press <MANUAL> on the IRC-6, or skip to step 2.
2. Select the color to be edited, from <R> (red), <G> (green), <B> (blue),
<A> (amber), <UV/P> (UV), or <W>. (white).
3. Press <+> or <–> to increase or decrease the value of the selected color.
4. Repeat steps 2 and 3 until the product outputs as desired.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe.
1. Press <%> on the IRC-6.
2. Press <+> or <–> to increase or decrease the output level.
1. Press <BLACK OUT> on the IRC-6.
Page 12 of 17